Bosch VJT-X40SN and VideoJet X SN encoders belong to a family of high-performance, single, dual, or quad input CCTV video IP encoders that feature DVD-like quality MPEG-4 video, at up to 30 images per second, over IP networks. The Bosch VJT-X40SN units support PAL/NTSC sources and provide bidirectional audio communication in parallel to video. They are built into a housing that can be easily wall-mounted or rack-mounted. These powerful and flexible devices represent the cutting edge of high performance video over IP for CCTV today.

Functions

Viewing

You can View the Bosch VJT-X40SN VideoJet X SN encoder video on a PC using a Web browser, in the Bosch Video Management System, or integrate it into another video management system. By routing the IP video to a high performance VIP XD video decoder or a VIDOS Monitor Wall, you can present the video with ultimate clarity.

Dual Streaming

The Bosch VJT-X40SN VideoJet X SN encoder uses Dual Streaming to generate two independent IP video streams per channel if sufficient computational power is available. This allows viewing and recording at two different quality levels to save disk space and bandwidth. On alarm, they can send an e-mail with JPEG images attached.

Flexibility

Bosch VJT-X40SN VideoJet X SN encoders offer unparalleled recording flexibility. Stream video across the network and store it using Network Video Recorders (NVRs). Record locally on CompactFlash, an external USB hard drive, or network attached RAID iSCSI storage devices. The built-in iSCSI
support enables the VideoJet X SN Bosch VJT-X40SN encoders to act as conventional DVRs while streaming high performance live video across the network.

Frame Rates and Resolution

When one or two inputs are used, the Bosch VideoJet X SN encoder delivers MPEG-4 video over IP at a full frame rate of 25 (PAL) or 30 (NTSC) images per second with up to 4CIF resolution on every channel. If four inputs are used, the maximum frame rate is 12.5/15 images per second at 4CIF resolution and no Dual Streaming is possible. The maximum frame rates listed in the table below depend on the resolution, picture content and movement, and the number of inputs used.

       4 inputs      2 inputs    1 input
4CIF  12.5/15ips   25/30 ips    25/30 ips
2/3D1 25/30ips     25/30 ips    25/30 ips
2CIF  25/30ips     25/30 ips    25/30 ips

ips = frame rate in images per second

Recording Profiles

The Bosch VJT-X40SN encoders feature a highly flexible recording scheduler, providing up to ten programmable recording profiles and allowing individually assigned camera profiles. With these profiles, you can accelerate the frame rate as well as increase the resolution on alarm, saving recording space during non-alarm periods.

Access Security

The Bosch VJT-X40SN VideoJet X SN encoder offers various security levels for accessing the network, the unit, and the data channels. As well as password protection with three levels, they support 802.1x authentication using a RADIUS server for identification. You can secure Web browser access by HTTPS using a SSL certificate that is stored in the unit. For total data protection, each communication channel – video, audio, or serial I/O – can be independently AES encrypted with 128-bit keys, once the Encryption Site License has been applied.

Intelligence

 With built-in video content analysis, Bosch VideoJet X SN VJT-X40SN encoders reinforce the Intelligence-at-the-Edge concept where edge devices become increasingly intelligent. The VideoJet X SN comes with built-in MOTION+ video motion detection. This motion detection algorithm is based on pixel change and includes object size filtering capabilities and sophisticated tamper detection capabilities.
 Bosch offers more advanced video content analysis (VCA) applications with its Intelligent Video Analysis (IVA). A licensable option, it bases the IVA algorithm on digital imaging technology that uses multi-level image analysis of pixel, texture, and motion (trajectory) changes.

Easy Upgrade

Remotely upgrade the VideoJet X SN Bosch encoders whenever new firmware becomes available. This ensures up-to-date products, thus protecting investment with little effort.

• High-quality MPEG-4 video over IP
• Units with one, two, or four video inputs
• Built-in Intelligence-at-the-Edge
• Network-attached RAID storage via iSCSI
• Local recording on CF card or USB hard drive

Electrical

Power supply     Via external unit or external battery
Input voltage      10 to 30 VDC
Power consumption    X10: approx. 11 VA, fully equipped
                     X20/X40: approx. 19 VA, fully equipped
Input/output

Video

X10: 1 x input
X20: 2 x input
X40: 4 x input
connector: BNC
impedance 75 ohm, switchable
signal Analog composite, 0.7 to 1.2 Vpp, NTSC or PAL

Audio

X10: 1 x mono line in, 1 x mono line out
X20/X40: 2 x mono line in, 1 x mono line out
connector 2 x 3.5 mm stereo jack
signal line in 9 kohm typical, 5.5 Vpp max
signal line out 3.0 Vpp at 10 kohm / 1.7 Vpp at 16 ohm typical

Alarm       4 x input

connector Clamp (non-isolated closing contact)
activation resistance 10 ohm max

Relay 4 x output
connector Clamp
signal 30 Vpp, 2 A
COM port Clamp, RS-232/422/485

Video

Standards MPEG-4, M-JPEG, JPEG
Data rates 9.6 kbps to 6 Mbps per channel
Resolution Horizontal x vertical PAL/NTSC
4CIF X10/X20: 704 x 576/480 (25/30 ips*)
X40: 704 x 576/480 (12.5/15 ips*; all inputs
used)
2CIF 704 x 288/240 (25/30 ips*)
2/3 D1 464 x 576/480 (25/30 ips*)
1/2 D1 352 x 576/480 (25/30 ips*)
CIF 352 x 288/240 (25/30 ips*)
QCIF 176 x 144/120 (25/30 ips*)
* Depending on picture content and movement
GOP structure I, IP
Overall IP delay 120 ms
Frame rate 1 to 50/60 (PAL/NTSC)

Audio
Standard G.711; 300 Hz to 3.4 kHz
Data rate 80 kbps at 8 kHz sampling rate

Network
Ethernet 10/100 Base-T, auto-sensing, half/full duplex,
RJ45
Protocols RTP, Telnet, UDP, TCP, IP, HTTP, HTTPS, DHCP,
IGMP V2/V3, ICMP, ARP, RTSP, SMTP, SNTP,
SNMP (V1/V2c/V3 MIB-II), 802.1x
Encryption TLS 1.0, SSL, AES (optional)

Control

Software update Flash ROM, remote programmable
Configuration Configuration Manager or Web browser

Connections

CompactFlash 1 x CF slot for optional standard Type I/II CompactFlash
memory card
USB port 1 x USB 2.0 high-speed port, 2.5 W max feed

Mechanical

Dimensions (H x W x D) 33 x 142 x 178 mm (1.3 x 5.6 x 7 in)
Weight Approx. 0.6 kg (1.3 lb)

Environmental

Operating temperature 0 °C to +50 °C (32 °F to +122 °F) ambient temperature
Relative humidity 20 to 80% atmospheric humidity, non-condensing
Thermal value X10: 37 BTU/h max, fully equipped
X20/X40: 65 BTU/h max, fully equipped

AVAILABLE MODELS

Ordering Information

VJT-X10SN VideoJet X10 Normal Temp          VJT-X10SN
VideoJet X10 SN with 1 video input

VJT-X20SN VideoJet X20 Normal Temp          VJT-X20SN
VideoJet X20 SN with 2 video inputs

VJT-X40SN VideoJet X40 Normal Temp          VJT-X40SN
VideoJet X40 SN with 4 video inputs

Accessories

VJT-XACC-PSN                                         VJT-XACC-PSN
VJX10/20/40 wide-range power supply

VJT-XACC-RMK VJT-X SN Rack-mount Kit for 3 Units     VJT-XACC-RMK
Rack mounting kit for 3 VJT-Xxx SN units.

DVA-12T-04050RA                                       DVA-12T-04050RA
iSCSI RAID5, 12 bay 1.5 TByte net capacity (4 hard drives installed)

DVA-12T-12050RA                                       DVA-12T-12050RA
iSCSI RAID5, 12 bay, 5.5 TByte net capacity (12 hard drives installed)

Software Options

VJT-X10SN-FS1                                     VJT-X10SN-FS1
VideoJet X10SN IVMD 1.0 VCA License

VJT-X20SN-FS1                                     VJT-X20SN-FS1
VideoJet X20SN IVMD 1.0 VCA License 2CH

VJT-X40SN-FS1                                     VJT-X40SN-FS1
VideoJet X40SN IVMD 1.0 VCA License 4CH

VJT-X10SN-FS3                                    VJT-X10SN-FS3
VideoJet X10SN IVA 3.0 VCA License

VJT-X20SN-FS3                                    VJT-X20SN-FS3
VideoJet X20SN IVA 3.0 VCA License, valid for 2 channels

VJT-X40SN-FS3                                    VJT-X40SN-FS3
VideoJet X40SN IVA 3.0 VCA License, valid for 4 channels

MVC-FENC-AES BVIP AES 128 Bit Encryption         MVC-FENC-AES    

BVIP AES 128-bit encryption site license. This license is required only once per installation. It enables encrypted communication between BVIP encoders, decoders and management stations.