(866) 441-2288 M-F 8:00AM 6:00PM Central Time

How to Enable Remote Access to a Security Camera or Recorder from Netgear Router?

To port forward a Netgear router, open your browser and type your IP Address into the bar and hit enter. If you do not know your IP address, type CMD into the Run tool and then type IPCONFIG. Write down the IP address to the right of IPv4 Address.

Once at the Netgear page, hit ADVANCED and go to Port Forwarding (located on the left).

Hit “Add Service.”

This will take you to the Port Forwarding page.

From here, type in IP Address and the ports you wish to open to it. Also, for organizational purposes, we suggest putting in the exact name of the hardware being opened in the name bar, such as “IP Camera 1”. Keep both TCP and UDP open.

When everything is punched in, hit APPLY and that’s it!


Customer Reviews

Average Rating based on 0 ratings

5 Star
4 Star
3 Star
2 Star
1 Star

0.00 % recommend

based on 0 recommendation


Would you recommend this item ?

Yes No

Write A Review

New post

    Most Helpful

No Reviews

    Most Critical

No Reviews

No posts found

Knowledge Base Articles