Speco SXP400 400W Solar Powered Camera Enclosure System with PoE Switch

Speco SXP400 400W Solar Powered Camera Enclosure System with PoE Switch

The Speco SXP400 is a complete 400W solar power system for IP camera deployments at sites without utility power. It pairs a pole-mounted solar array with a weatherproof aluminum enclosure that houses the charge controller, PoE switch, converters, and charging equipment in a single self-contained, tamper-resistant unit. Solar panels and mounting hardware are included, as is the enclosure mounting hardware, making this a deployable package rather than a component set.

Power management uses an advanced solar charge controller with a Maximum Power Point Tracking (MPPT) algorithm, which optimizes array output against battery state and ambient conditions for higher charge efficiency than conventional PWM control. The array delivers 24VDC output and the integrated PoE switch supports both IEEE 802.3af devices up to 15.4W and IEEE 802.3at devices up to 25.5W. Available power for camera use varies by solar zone, ranging from 55W in the sunniest regions down to 9W in the least sunny; the system is not recommended for Alaska or Canada.

The aluminum enclosure measures 32" (H) x 24" (W) x 16" (D) and weighs 28 lbs, accommodating up to four 100Ah batteries (batteries not included; each measures 9.2" H x 12.3" W x 6.7" D). It secures with a lockable wing-knob accepting a standard padlock (padlock not included) and mounts to a 4" to 6" pole, with straps not included. The panel assembly weighs 120 lbs with its mount, is rated to 100 mph wind, and is recommended for an 8" pole. Operating range spans -40°F to 140°F. The system carries network operator certifications for AT&T, T-Mobile, and Verizon; a SIM card is not included.

Key Features:

• 400W solar array with mounting hardware included; provides grid-independent power for remote IP camera sites.
• MPPT solar charge controller; maximizes charge efficiency against battery state and ambient conditions compared with standard PWM control.
• Hardwired PoE switch supporting IEEE 802.3af (15.4W) and 802.3at (25.5W); powers connected cameras directly from the enclosure.
• Weatherproof aluminum enclosure, 32" x 24" x 16"; safeguards switch, converters, and charging equipment from weather and tampering.
• Lockable wing-knob closure accepting a standard padlock; deters unauthorized access at unattended sites.
• Capacity for four 100Ah batteries (not included); supports extended autonomy through low-sunlight periods.
• 24VDC output voltage; matches the system's charging and distribution equipment.
• 100 mph panel wind rating on a recommended 8" pole; withstands severe weather at exposed installations.
• Operating range of -40°F to 140°F; suits year-round deployment across most North American climates.
• AT&T, T-Mobile, and Verizon network operator certifications; simplifies pairing with cellular connectivity (SIM card not included).