Altronix AL300ULMR Access Power Distribution Module with Power Supply/Charger - 5 PTC Class 2 Outputs

(No reviews yet) Write a Review
SKU:
AL300ULMR
$184.64
Frequently bought together:

Description

Altronix AL300ULMR Access Power Distribution Module with Power Supply/Charger - 5 PTC Class 2 Outputs

AL300ULMR multi-output access control power supply/charger is specifically designed for use with access control systems and accessories. This unit converts a 115VAC / 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs. Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. These outputs will operate in both Fail-Safe and Fail-Secure modes. Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or may be used to trigger auxiliary devices.

Key Features:

  • Input
    • Input 115VAC / 60Hz, 3.5A.
    • Input fuse rated @ 3.5A/250V.
    • Fire Alarm Panel or Access Control System trigger inputs. N.O. or N.C.supervised trigger input and polarity reversal trigger input.
  • Output
    • 12VDC or 24VDC selectable outputs.
    • 2.5A supply current.
    • Five (5) (auto-resettable) PTC protected outputs, rated @ 2A.
    • Output relay energizes when unit is triggered (form "C" contact rated 1A @ 28VDC).
    • Filtered and electronically regulated output.
    • Short circuit and thermal overload protection.
  • Battery Backup
    • Built-in charger for sealed lead acid or gel type batteries.
    • Automatic switch over to stand-by battery when AC fails.
  • Supervision
    • AC fail supervision (form "C" contacts).
    • Notification trigger is selectable for 30 seconds (factory set) or 6 hours.
    • Low battery supervision (form "C" contacts).
    • Battery presence supervision (form "C" contacts).
    • Power fail supervision relay (form "C" contacts).
  • Visual Indicators
    • AC input and DC output LED indicators (power supply board).
    • Red LEDs indicate condition of power outputs (multi-output board).
    • Power & input trigger LEDs(multi-output board).
  • Temperature
    • Operating: 0° C to 49° C ( 32° F to 120° F ).
    • Storage: - 20° C to 70° C ( -4° F to 158° F ).
    • Relative Humidity 85% +/- 5%.
      • BTU/Hr (approx.):
        • 12VDC: 15 BTU/Hr.
        • 24VDC: 31 BTU/Hr.
    • System AC input VA requirement: 166.75VA.

Downloads

View AllClose

Additional Information

Warranty:
Life-time Warranty
View AllClose

Customers Also Viewed