Altronix eFlow104NA8D Access Power Controller with Power Supply/Charger - 8 PTC Class 2 Relay Outputs

Brand: Altronix
Part Number: eFlow104NA8D
Write a Review
$334.11
Free shipping over $300 Free Shipping
Technical Support Technical Support
Lifetime Warranty Lifetime Warranty

Description

Altronix eFlow104NA8D Access Power Controller with Power Supply/Charger - 8 PTC Class 2 Relay Outputs

eFlow104NA8D distributes and switches power to access control systems and accessories. It converts a 120VAC 60Hz input into eight (8) independently controlled 24VDC PTC protected outputs. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Key Features:

  • Input
    • Input 120VAC 60Hz, 4.5A.
      • Power supply input options:
        • a) One (1) common power input for ACM8CB and lock power (factory installed).
        • b) Two (2) isolated power inputs - One (1) to power the ACM8CB and one (1) for lock accessory power (external power supply is required). Current is determined by the power supply connected, not to exceed a maximum of 10A total.
    • Eight (8) Access Control System trigger inputs.
      • Input options:
        • a) Eight (8) normally open (NO) inputs.
        • b) Eight (8) open collector inputs.
        • c) Any combination of the above.
    • ACM8CB board main fuse is rated at 10A.
  • Output
    • 24VDC outputs @ 10A supply current.
    • Power-limited outputs.
    • Eight (8) independently trigger controlled outputs.
      • Output options:
        • a) Eight (8) Fail-Safe filtered power outputs.
        • b) Eight (8) Fail-Secure filtered power outputs.
        • c) Any combination of the above.
    • Eight (8) unswitched filtered aux. power outputs (outputs are rated @ 2A).
    • Over Voltage protection.
    • Short circuit and thermal overload protection.
  • Fire Alarm Disconnect
    • Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
      • Fire Alarm disconnect input options:
        • a) Normally open (NO) or normally closed (NC) dry contact input.
        • b) Polarity reversal input from FACP signaling circuit.
    • Alarm output relay indicates that FACP input is triggered (form "C" contact rated @ 1A 28VDC not evaluated by UL).
  • Supervision
    • AC fail supervision (form "C" contacts).
    • Battery fail & presence supervision (form "C" contacts).
    • Low power shutdown. Shuts down DC output terminals if battery voltage drops below 70-75% (depending on the power supply). Prevents deep battery discharge.
  • Visual Indicators
      • ACM8CB Access Power Controller:
        • Red LEDs indicate outputs are triggered (relays energized).
        • Green LED indicates FACP disconnect is triggered.
      • eFlow Power Supply Board:
        • AC input and DC output LED indicators.
  • Battery Backup
    • Built-in charger for sealed lead acid or gel type batteries.
    • Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption.
    • Zero voltage drop when unit switches over to battery backup (AC failure condition).
  • Electrical
      • Temperature:
        • Operating: 0° C to 49° C (32° F to 120° F).
        • Storage: - 20° C to 70° C ( - 4° F to 158° F).
    • Relative Humidity: 85% +/- 5%.
      • BTU/Hr (approx.):
        • 24VDC: 123 BTU/Hr.

Downloads

Additional Information

Warranty:
Life-time Warranty
View AllClose

Customers Also Viewed

8 Megapixel (4K) InfraRed for Night Vision Outdoor Dome Network (IP) Security Camera, H.265 Plus Compression, Weatherproof, SD Card Support, 2.8mm Fixed Lens, CMIP7382NW-28M

8 Megapixel (4K) InfraRed for Night Vision Outdoor Dome Network (IP) Security Camera, H.265 Plus Compression, Weatherproof, SD Card Support, 2.8mm Fixed Lens, CMIP7382NW-28M

CMIP7382NW-28M
$233.87
  • Compression : MJPEG, H.264, H.265, H.265 Plus,
  • Field of View (Horizontal) : 102°Field of View
  • Max. FPS and Resolution : 15fps at 3840 x 2160
  • Lens Type : Fixed Lens
  • Lens Size : 2.8mm Lens
  • Sensor Type : CMOS
  • Sensor Size : 1/2.5" Sensor
  • Max. Storage Capacity : 128 GB Storage Capacity
  • Protection Code : IP67 IK10
  • Color : White
  • Environmental : Outdoor
  • Sensor Size : 1/2.5"
Network (IP) Network (IP)
8MP (4K) 8MP (4K)
100 100 Night Vision
White White